In addition, 9.5 mm (0.374 in), and 3⁄ 8 in (0.375 in) will work well, although major minus pitch by itself does not tell you this but the 85% ± 2 pp guideline supports it. The drill sizes that are near this are 9.3 mm (0.366 in) and letter U (0.368 in).The major minus pitch also works for inch-based threads, but you must first determine the pitch by looking at the number of treads per inch (TPI for example, 1⁄ 20 = 0.050 and 1⁄ 13 ≈ 0.077), and your result will only land near a tap drill size (not directly on one).(The 85% coarse, 90% fine guideline, within its effective range, matches this in net effect).For metric V threads, major minus pitch yields a good tap drill diameter.The drill sizes that are near this are 15⁄ 64 in (85%), 6.0 mm (85.7%), and 6.1 mm (87.1%) any of these will work well.Example (metric, coarse): For M7.0×1.0 (an intended screw with a diameter of 7.0 mm and a pitch of 1 mm between each thread, which is considered coarse), 7.0 mm × 0.85 = 5.95 mm.Example (inch, fine): For 7⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw). ![]() Therefore, a size 7⁄ 16 screw ( 7⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |